Troubleshooting - Wagan Tech SmartAC 425W Manual De Usuario

TROUBLESHOOTING

PROBLEM: Low or No Output Voltage – Fault LED Lit
Reason
Poor contact with battery or inverter
terminals.
PROBLEM: Inverter Automatically Shut Down – Fault LED Lit
Reason
Battery voltage below 10V
Inverter is too hot.
(Thermal protection mode.)
Unit may be defective.
Equipment being operated draws too
much power.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2020 Wagan Corporation. All Rights Reserved.
Solution
Clean terminals thoroughly. Reinstall
and tighten.
Solution
Charge or replace battery.
Allow inverter to cool.
Check for adequate ventilation.
Reduce the load on the inverter to
rated continuous power output.
See warranty and call customer
service.
Use a higher capacity inverter or do
not use this equipment.
10