Flex SE 125 18.0-EC Instrucciones De Funcionamiento Originales página 22

Connecting an extraction system
NOTE
It is recommended to use the FLEX special
extractor VCE 44 M AC .
 Attach the suction hose to the connection
of the protective hood.
 Connect the suction hose to the dust
extraction system. Observe the operating
instructions of the dust extraction system.
Check the attachment.
 Slide the enclosed adapter onto the suction
connection of the suction hood.
 Connect the suction hose.
Attaching/changing the Velcro
sandpaper
 Remove the battery.
 Remove worn sanding tool from the
backing pad.
 Place the Velcro sandpaper in the centre
of the backing pad and press on.
Note position of the holes to ensure that
the sanding dust is extracted.
 Conduct a test run to check that the
sanding tool is clamped in the centre.
22
Working with flap sanding discs
NOTE
Flap sanding discs are a component of the
"Metal working" accessory set.
 Remove the battery.
 Press and hold down the spindle lock.
NOTE
If the Velcro pad is stuck, hold the gear shaft
in place using an Allen key
 Loosen the Velcro pad by hand or using
a two-hole wrench (2.).
 Screw Velcro pad anti-clockwise off the
spindle.
 Place clamping flange (A) on spindle.
 Place flap sanding disc (B) on clamping
flange.
 Screw the clamping nut (C), with flange
face up, onto the spindle.
SE 125 18.0-EC
(1.).