Installing And Removing The Battery Pack - Black+Decker LSwV36 Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

ImpoRTANT CHARgINg NoTES

1. Longest life and best performance can be obtained if the battery

pack is charged when the air temperature is between 60°F and 80°F

(16°- 27°C). DO NOT charge the battery pack in an air temperature

below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important

and will prevent serious damage to the battery pack.

2. The charger and battery pack may become warm to touch

while charging. This is a normal condition, and does not indicate

a problem. To facilitate the cooling of the battery pack after use,

avoid placing the charger or battery pack in a warm environment

such as in a metal shed, or an uninsulated trailer.

3. If the battery pack does not charge properly:

a. Check current at receptacle by plugging in a lamp or other

appliance

b. Check to see if receptacle is connected to a light switch

which turns power off when you turn out the lights.

c. Move charger and battery pack to a location where the surrounding

air temperature is approximately 60°F - 80°F (16° - 27°C).

d. If charging problems persist, take the tool, battery pack and

charger to your local service center.

4. The battery pack should be recharged when it fails to produce

sufficient power on jobs which were easily done previously.

DO NOT CONTINUE to use under these conditions. Follow the

charging procedure. You may also charge a partially used pack

whenever you desire with no adverse affect on the battery pack.

5. Foreign materials of a conductive nature such as, but not limited

to, steel wool, aluminum foil, or any buildup of metallic particles

should be kept away from charger cavities. Always unplug the

charger from the power supply when there is no battery pack in the

cavity. Unplug charger before attempting to clean.

6. Do not freeze or immerse charger in water or any other liquid.

wARNINg:

Shock hazard. Do not allow any liquid to get

inside charger. Never attempt to open the battery pack for any

reason. If the plastic housing of the battery pack breaks or cracks,

return to a service center for recycling.

STATE of CHARgE INDICAToR (fIguRE B)

The back of the battery is equipped with a state of charge indicator. This

can be used to display the current level of charge in the battery during use

and during charging. It does not indicate tool functionality and is subject

to variation based on product components, temperature and end-user

application.

Checking state of charge during use:

• Press the state of charge indicator

button (B1).

• The three LED's (B2) will illuminate

indicating the percent of charge in the

battery. See chart in figure B.

• If LED light does not lluminate,

charge battery.

NoTE:

This battery is designed to not

operate when a charge below 20% of

its capacity is reached. After the battery

charge is depleted, the tool will not

operate until after the battery has been recharged.