Black+Decker LSwV36 Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SwEEpER moDE ASSEmBLy
NoTE: Ensure the sweeper is switched off and the battery is
removed before attaching or removing the sweeper tubes. The
tube assembly must be assembled to the housing before use.
• TuBE ASSEmBLy: To attach the two piece sweeper tubes to the
sweeper, line up the tube with the sweeper housing as shown in
figure D. Push the tube into the sweeper housing until the lock
lever engages the lock hole in the tube.
• fAN CoVER ASSEmBLy: To attach the fan cover to the
sweeper, line up the tabs on the cover with the sweeper housing
slots as shown in figure D1. Push the cover into the sweeper
housing until the locking/release button is fully engaged. (This
comes pre-assembled from the factory).
D
VACuum moDE ASSEmBLy
CoLLECTIoN BAg (fIguRE E)
• Remove sweeper tube if attached.
• Push the collection bag on to the
sweeper housing until the lock lever
engages the lock hole as shown in
figure E.
D1
E
8
• Attach collection bag clip to the lower
rear of the unit as shown in figure E1.
VACuum TuBE ASSEmBLy (fIguRES f, g, H, H1)
NoTE: Ensure the sweeper is switched off and the battery is removed
before attaching or removing the vacuum tubes. The vacuum tube and
collection bag must be assembled to the housing before use.
• Vacuum tubes must be assembled together before use.
• Align the notches and the triangles on
upper and lower tubes. (figure f)
• Push the lower tube firmly into the
upper tube, until the triangles click into
place. (Never operate apart).
• In the interest of safety, it is not
intended for the tubes to be separated
once assembled.
• Remove the fan cover from the side of
the sweeper housing by pressing the
spring loaded release button (located
on the lower right side of the sweeper
housing) and pulling the cover off
(figure g). Fan cover can be stored in
pouch on collection bag.
E1
F
G

Publicidad

Tabla de contenido
loading

Tabla de contenido