Sweeper Operation - Black+Decker LSwV36 Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

• Attach the vacuum tube assembly to

the fan inlet on the sweeper housing

(figure H) by lining up the tabs on the

tube with the slots on the sweeper

housing and push inwards until

the locking/release button is fully

engaged. (figure H1)

• Vacuum tube assembly can be stored

by hanging on a wall with a nail,

using the built in hang hole on the

underside of the tube.

opERATIoN

ALwAyS wEAR SAfETy gLASSES. wEAR A fILTER mASk If

THE opERATIoN IS DuSTy. uSE of RuBBER gLoVES AND

SuBSTANTIAL fooTwEAR IS RECommENDED wHEN woRkINg

ouTDooRS. foR HouSEHoLD uSE oNLy.

wARNINg:

CuT HAzARD. When turning the tool off for

tube installation or any other reason, wait 10 seconds for the fan

to stop rotating before disassembly.

• Do not use in vacuum mode without the vacuum tubes and

collection bag in place.

• Always switch off and remove the battery when:

• Changing from blower to vacuum.

• The power supply cord has become damaged or entangled.

• You leave blower/vac unattended.

• Clearing a blockage.

• Checking, adjusting, cleaning or working on blower/vac.

use blower/vac only in daylight or good artificial light.

SwITCHINg oN AND off (fIguRE I)

wARNINg:

uSE BoTH HANDS To

gRIp THE pRoDuCT fIRmLy wHEN

SwITCHINg oN.

To switch the sweeper on, slide the on/off

switch forward.

To switch the sweeper off, slide the on/off

switch back.

CAuTIoN:

DO NOT POINT UNIT

DISCHARGE AT SELF OR BYSTANDERS.

powER CommAND (fIguRE j)

mAX powER / mAX RuNTImE

The max power / max runtime feature

(j1) is located on the tool handle.

It allows you to optimize the tools

performance and boost the power as

needed.

• To choose max power, rotate dial

to setting 6. (most vacuuming tasks

require max power.)

• To maximize runtime rotate dial to setting 1.

• For a combination of both, rotate dial to setting from 2 to 5.