General Information - Anthron AD-10 Ficha Técnica

Figure 6: MIXED PROGRESSION
Avoid exceeding the height of the attachment to the rope with the point of
attachment to your harness (always keep the fall factor < 1). Because of a
danger of a fall a 10 mm or thicker rope must be used.
Figure 7: HORIZONTAL PROGRESSION
As shown on figure 7.
Figure 8: HAULING SYSTEM
In any hauling system composition shown in figure 8 an ascender (AD-10, AL-
15) may be replaced by a bloquer (AB-20).

GENERAL INFORMATION

Packing, storage, maintenance and cleaning
Each product is packed with its INSTRUCTIONS FOR USE in a card box.
Proper maintenance and storage are imperative to ensure correct functioning
of the product (as well as all your equipment) and thus your safety.
Clean the product with a brush under running cold water of domestic supply. If
the stains persist, clean it in warm water (maximum 30 °C) with ordinary soap.
Then rinse thoroughly, wipe it with a towel and dry naturally in a shaded
ventilated place away from sources of heat.
If needed, lube sparingly the moving joints of the cam with silicon based oil.
Temperatures
While it is allowed to use this product within the temperature range from -40 °C
to +60 °C, it is advisable to stock it in a dry place at room temperature.
Lifetime
Lifetime is set by the date of production and is theoretically unlimited.
Service time starts with the date of first use and depends on frequency and
mode of application, on environment where it is used (e.g. marine, cave,
corrosive atmosphere), and on mechanical wear and damage. It is therefore
very difficult to determine the expected service time of a particular device.
Its due retirement is therefore left to user's regular examinations and
competent person's annual inspections.
Guarantee and its limitations
This product is guaranteed for 3 years from purchase against any faults in
materials or manufacture. The guarantee does not apply in cases of misuse,
normal wear and tear, unauthorized modifications or alterations, improper use,
improper maintenance, accident, negligence, damage, or if the product is used
for a purpose it was not designed for. If you discover a defect, you should return
the product to the reseller you purchased the product from or directly to
ANTHRON.
ANTHRON is not responsible for the consequences of direct, indirect,
accidental or any other type of damage resulting from the use of its
products.