Publicidad
Step 8
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (40MA) to the RIGHT END (A) and LOWER
å
UPRIGHT (I). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
å
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to fi nd
the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the LARGE DRAWER SIDES.
å
Push the black lever in and pull the SLIDE from the RAIL.
Open end
www.sauder.com/services
40MC
I
GOLD 5/16" FLAT HEAD SCREW
A
3S
(4 used in this step)
422194
40MA
Open end
D
Page 13
Publicidad
