Publicidad
Step 21
NOTE: You will need to use a short screwdriver in this step.
å
Before fastening the DOOR (P) to your unit, be sure the mounting
å
screw is against the stops as shown in the right diagram. If it isn't,
loosen the mounting screw to slide it against the stops. Then tighten
the mounting screw.
Fasten the DOOR (P) to the LOWER UPRIGHT (I) as shown in the
å
lower diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
Fasten the KNOB (24K) to the DOOR (P) with a short screwdriver. Use
å
the BLACK 1-1/8" MACHINE SCREW (21S).
Peel a bumper from the BUMPER CARD (29M) and stick one on each
å
corner of the DOOR (P) where it comes in contact with the SHELF (O)
and BOTTOM (N) when closed.
See the next step for DOOR adjustments.
å
Page 26
N
BLACK 1-1/8" MACHINE SCREW
(1 used in this step)
422194
Stop
Mounting
screw
Hinge
O
I
P
24K
21S
www.sauder.com/services
29M
Publicidad
