Publicidad
Step 26
1
D107
M
Groove
Insert the SMALL DRAWER SIDES (D107 and D108) at
å
an angle into the slot at each end of the SMALL
DRAWER FRONT (M).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Fasten the SMALL DRAWER BACK (D109) to the SMALL DRAWER SIDES (D107 and D108). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D707) inserts into the groove of the SMALL DRAWER BACK (D109).
å
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D108
D109
D707
D107
2
U n
s u
D107
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D707 ) into the grooves in the
å
SMALL DRAWER SIDES (D107 and D108) and
SMALL DRAWER FRONT (M).
D108
422194
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
fi n
i s h
r f a
e d
c e
D707
D108
M
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
Page 31
Publicidad
