Publicidad
Step 14
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the RIGHT END (A) and UPRIGHT (C) until the shoulders of the
å
SCREWS rest on the surfaces of the END.
NOTE: Do not overtighten the SCREWS.
å
Slide the RIGHT END MOLDINGS (K) onto the RIGHT END (A) and UPRIGHT (C). Line up the grooves in the MOLDINGS over
å
the heads of the SCREWS in the END and UPRIGHT.
NOTE: The MOLDINGS should be even with the top edges of the END and UPRIGHT.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Apply pressure toward the END with
your hands as you guide the MOLDING
over the SCREWS and onto the END.
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
Shoulder
A
Shoulder
32S
The groove should be against
the END and UPRIGHT.
K
422194
Apply pressure toward
the UPRIGHT with
your hands as you
guide the MOLDINGS
over the SCREWS and
onto the UPRIGHT.
K
C
BLACK 9/16" FLAT HEAD SCREW
32S
Page 19
Publicidad
