q Auto Iris lens Connector
This connector is for connecting auto iris lens by a
4-pin male connector supplied as a standard
accessory (Part No. YFE4191J100).
w Back-focal Adjusting Ring
This ring is adjusts the back-focal length or picture
focus. Rotate this ring clockwise for a C-mount
lens or counterclockwise for a CS-mount lens.
e Lens (option)
r Camera Mounting Screw Hole
This hole is for mounting the camera onto a mount-
ing bracket.
t Power Cord (only WV-BP330)
Connect this power cord to an electrical outlet of
220-240V AC 50Hz.
y DC 12 V Input Terminal
(DC 12V IN (only WV-BP332))
This terminal is for connecting the 12V DC power
supply cord.
u AC 24V Input Terminal
(AC 24V IN (only WV-BP334))
This terminal is for connecting the 24V AC 50Hz
power supply cord.
i Synchronization Mode Selector
(INT, LL (only WV-BP330 and WV-BP334))
Selects the camera synchronization mode from
internal sync mode (INT) or line-lock mode (LL).
INT: When no signal is supplied to the GEN-LOCK
connector, the camera synchronization mode
is set to internal 2:1 interlace. Whenever the
gen-lock video signal is supplied to the GEN-
LOCK connector, the camera synchronization
mode is automatically set to external synchro-
nization.
LL: The camera synchronization mode is set to
line-lock even if the gen-lock video signal is
supplied to the GEN-LOCK connector.
Note: Set this selector to INT for gen-lock opera-
tion.
o AGC ON/OFF Selector (AGC ON, OFF)
Selects the gain of the video amplifier as follows:
AGC ON: When the lens iris is fully open under
low light condition, a clear picture is obtained
by automatic increase of the gain.
OFF: A natural and low-noise picture is obtained
under low light conditions.
-6-