Setting The Time - Health O Meter 7632 Manual De Instrucciones

Replace the batteries if:
1. The weak battery mark appears in the display.
2. Nothing appears in the display when the power is switched on.
As the supplied batteries are for test only, they may discharge earlier than batteries
you buy in stores. Replace the batteries in pairs.
Remove batteries when unit is not in use for extended periods of time.
Note: Discard used batteries as directed by your local, environmental codes.

Setting the Time

1. To set/adjust the date and time in the monitor, press the "Set" Button
on the top surface of the monitor. The display will show a blinking number showing
the month.
2. Change the month by pressing the
increase the number by one in a cycling manner. Press the Set Button
to confirm the entry, and the screen will show a blinking number representing the
number of the day in the month.
3. Change the date, the hour and the minutes as described in Step 2 above,
using the
4. A "0" will reappear as the Blood Pressure Monitor is ready for measurement again.
button to change and the
button. Each press of this button will
button to confirm the entries.
Press the Set Button
Month Position Will Blink
Press To Select Month
Press To Confirm Selection
10
located
again