Adjust Menu; Lock Setup; How To Use The Password Function - Haier L26F6 El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Basic Receiving and Playing Operations
Sun. Mon. Tues. Wed. Thur. Fri. Sat.
.
Reset
Return to factory default settings. Press VOL- / VOL+
to select OK or Cancel, Press OK to affirmance.

Adjust Menu

The TV can be used as a display, and you may adjust
relevant settings. Press INPUT to switch the signal input
to PC mode.
A
MENU to display the screen main menu, press
Press
CH+ /CH- to select the Adjust menu as shown in the
below figure, and then press OK/VOL+ to enter.
B
CH+ /CH- to select the option to be adjusted.
Press
C
VOL- / VOL+ to adjust it.
Press
Auto Adjust
Vertical and Horizontal position of picture can be
adjusted in this item.
Horizontal Position
This is used to adjusting Horizontal-size.
Vertical Position
This is used to adjusting Vertical-size.
Phase
This is used for adjusting Vertical position and
Horizontal position as well as relative parameters in
20 LCD television Owner's Manual
Calendar
PC modes.
Clock
This is used for adjusting the phase of pixel clock in
PC mode.
Reset
Return to factory default settings.

Lock Setup

The television has the function of security default lock.
Password needs to be entered when the program lock
mode is to be set.

How to use the password function

Press H. LOCK, the TV screen will display Enter Password
to prompt the user to enter a correct password by
pressing corresponding numerical keys; if the password
is correct, the user enters the Lock Set menu; if incorrect,
the user is required to enter a password again.
If there is no operation for a few seconds, the display will
automatically disappear.
The Lock Set menu is as follows:
Change password
After entering the Lock Set menu, press CH+ /CH- to
select the Change Password option, and then press
VOL- / VOL+ to display the Change Password menu,
afterwards enter a new 4-digit password by pressing
numerical keys and repeat entering this password
once, and finally select the option to be confirmed
and press MENU to confirm, indicating the successful
change of password.
If the user does not want to change the password in
halfway, he may press MENU to exit from this menu.
Note
The initial password is 0000, and the password setting
Return

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

L32f6L42f6

Tabla de contenido