Using The Raincover - Cosatto NITTY GRITTY Manual De Instrucciones

14 - fitting the drink and bottle holders
Drinks holder: Push the drinks holder down on to its mounting bracket until it locks in place (a).
Lift the drinks holder off the bracket to remove.
Note: It is not recommended to place hot drinks in the drinks holder due to the danger of spillage.
Bottle holder: Wrap the Velcro
(c) as shown.

15 - using the raincover

With the hoods opened or in the extended position, place the split, shorter section of the
raincover over the hood so that it hangs at the rear of the pushchair. The middle handle fits
through the hole in the cover (a).
At the front wrap the straps around the chassis and fasten the press studs (b).
At the back secure using the Velcro® tabs at the rear (c).
16 - removing the seats for cleaning
Secure attachment of the seat cover is critical to the safety performance of your
pushchair.
Removing and re-fitting involves a series of fasteners as shown below – please follow this
information carefully.
Tips:
• Having the pushchair semi-folded will release tension in the seat covers and make the fabric
sections easier to remove
• When passing the buckle through the plastic slots, keep the curve of the buckle in line with the
curve of the tubing and ease through the slot. If this is tight, use a blunt edge e.g. a coin or
broad screwdriver blade to help.
Unzip the top of the backrests and remove the three panels from inside (a).
Unfasten the Velcro
tubing (b).
Unclip the waist straps from the frame by unfastening, then feeding the edge of the webbing
through the opening of the metal clip (c).
Unclip the seat straps by folding the buckle flat and pushing it through the slot in the mounting
block (d). There are three buckles on each side of each seat cover. One at the top of the backrests
and two on the underside of the seats.
Undo the straps under the footrests (e).
Slide the seat covers off the footrest legs (f). Slide the seat covers off the backrest arms (g).
Reverse these steps to refit.
17 - folding the pushchair
Note: Before folding ensure the backrest is in the most upright position. Always
remove the raincover, placing it in the basket and fold the hood completely back.
To fold your pushchair lift the handles (a) and at the same time press down on the secondary
lock (b).
Keeping the secondary lock pressed down, push the handles forward until the pushchair is folded
in half. Continue until the pushchair is folded in half and the autocatch engages.
Note: Take care not to damage the stand mechanism when folding. Pressing
down too hard on the pushchair can bend the stand arms (c).
Check the autocatch is securely engaged before lifting the pushchair.
®
straps around the hinge at the top of frame (b) and the front leg
®
tabs at the rear of backrests holding the seat covers to the backrest