Fitting The Raincover - Cosatto TO & FRO NITTY GRITTY Manual Del Usuario

All manuals and user guides at all-guides.com
21 - fitting the drinks holder
Push the drinks holder down on to its mounting bracket until it locks in place.
Lift the drinks holder off the bracket to remove.
Note: The cup holder must only be used in forward facing mode.
22 - using the calf support - forward facing mode
Press the buttons on both sides of the calf support (a) and lift (b) or lower (c) the calf support to
the desired position. Release buttons (a) to lock the calf support in position.
23 - removing the basket
The basket is removable for easier cleaning. To remove your basket, undo the poppers on the four
straps, two at the back (a) on either side and two at the front behind the calf support hinges (b).
To re-fit your basket, simply reverse the above process. Maximum load 2kg of goods, evenly
distributed.
24 - using the child car seat adaptor
The child car seat adaptors are handed and can only be fitted in one direction. The hinged locking
flap should be on the outside of the pushchair once fitted.
Open an adaptor and working from underneath wrap around the pushchair leg just under the
hinge (a). Close the adaptor locking flap (b) to lock the adaptor to the pushchair leg. A 'click'
should be heard when the flap locks.
Rotate the adaptor around the pushchair leg until the adaptor foot aligns with the locking pin (c)
on the pushchair leg.
Slide down (d) until a 'click' is heard and the adaptor is locked in place. Repeat this procedure with
the other side.
To release the adaptors press the levers underneath (e) to lift them off the locking pins. Open the
locking flaps (f) and remove the adaptors from the pushchair (g).
The car seat adaptors can be folded down below the pushchair leg if the car seat is to be used
regularly (h) and remain attached during folding of the chassis.
25 - using the pushchair with the Hold car seat (sold separately)
Fit the car seat adaptor to the chassis (See step 24)
Lift the child car seat on to the pushchair and align the car seat mounts with the adaptors on the
pushchair. Push down firmly (a) until a 'click' is heard from both sides.
Before using the pushchair with the child car seat attached check that the child car seat and
adaptors are firmly attached.
To remove the child car seat press the buttons on both car seat mounts (b) then lift the car seat off
the car seat adaptors (c).

26 - fitting the raincover

The procedure for fitting the raincover is the same for parent facing, forward facing & car seat
mode.
Fit the raincover over as shown.
The handles pass through holes in the raincover on each side (a).
Fasten the fasteners, three on each side at the back of the raincover (b).
At the front wrap the webbing straps around the chassis legs and fasten the popper (c).
A zip fastener along the front of the raincover can be opened to gain access to the inside of the
raincover (d).