Vetus BMON Manual De Manejo Y Instrucciones De Instalación página 27

8 Complete overview of SETUP mode
• In order to enter SETUP mode press the '<' and the '>' but-
tons simultaneously until all LEDs light up and 'H?1' flashes in
the display.
• Hold the '<' and the '>' buttons depressed until the desired
function appears in the display.
• Use the '<' button to lower the value of a function and the '>'
button to raise the value.
• If a particular function has been missed while the display
jumps from one to the other it is not possible to return. Keep
both buttons depressed until the desired function reappears in
the display.
Function Description
H? ?1 Display brightness
H? ?2
Alarm for too low a voltage
H? ?3
Delay time for function H2
H? ?4 Alarm for too high a voltage
H? ?5
Delay time for function H4
H? ?6
Nominal battery capacity
Battery monitor
• In SETUP mode the function number and the value set for
the particular function are shown in the display alternately.
• Exiting SETUP mode and saving the data:
Hold the '<' and the '>' buttons pressed simultaneously until
'H?2?7' appears in the display and then release the '<' and the
'>' buttons.
• If no button is pressed for more than 30 seconds while in
SETUP mode then SETUP mode is automatically exited. No
data will then be saved!
Range Set value
1 .. 8 8 (=max.)
0 .. 32.6 V 10.8 V
0 .. 255 s 7 s
0 .. 32.6 V 31.2 V
0 .. 255 s 8 s
0 .. 995 Ah 100 Ah
Notes
A higher value corresponds to a brighter display
This value must be set the first time that the instru-
ment is used or when the battery is replaced
ENGLISH
27
9.0422