Flexibridge Max Bridge Mode - AEG IKE64473IB Manual De Instrucciones

6.4 FlexiBridge Max Bridge mode

To activate the mode touch
the correct mode indicator . This mode
connects all sections into one cooking zone.
To set the heat setting use any of the two
control bars on the left side.
Correct cookware position:
To use this mode you have to place the
cookware on the four connected sections. If
you use cookware smaller than three
sections the display shows
minutes the zone switches off.
Incorrect cookware position:
until you see
6.5
This function allows you to adjust the
temperature by moving the cookware to a
different position on the induction cooking
area.
The function divides the induction cooking
area into three areas with different heat
settings. The hob detects the position of the
cookware and adjust the heat setting
corresponding with the position. You can
place the cookware in the front, middle or
rear position. If you place the cookware in the
front you get the highest heat setting. To
decrease it, move the cookware to middle or
rear position.
and after 2
General information:
• 160 mm is the minimum bottom diameter
• Heat setting display for the left rear
PowerSlide
Use only one pot when you
operate the function.
of the cookware for this function.
control bar shows the position of the
cookware on the induction cooking area.
ENGLISH 17