Revell Control TECHNIK NIGHT FLASH Manual De Usuario página 17

Attention: The battery and motor must cool down for 15 to 30 minutes before
charging­and­after­every­flight.­Otherwise­they­can­be­damaged.­The­charging­pro­
cess must be constantly monitored. Always ensure that the charging process takes
place­on­a­fireproof­surface­in­a­fire-resistant­environment.
1. Switch off the helicopter (Switch 1F) and the remote control (Switch 2A).
2. Plug the USB charger into a USB hub or a USB port on a computer (4A).
If the charger is ready for operation, the LED on the top illuminates red.
3. Now insert the connector on the charger into the underside of the model
(charging port 1E) (4B).
The charging process begins automatically.
4. The Power LED on the charger goes out during the charging process and illumi­
nates red when the battery is full (4C). After charging, disconnect the battery
from the charger and pull the charger plug out of the USB interface.
The helicopter can fly for approx. 5-7 minutes after a charge time of
approx. 40 minutes.
Warning notice: The LiPo battery does not normally heat up while charging. If it
should become warm or even hot and/or changes to the surface begin to appear,
immediately discontinue the charging process!
You can also charge your helicopter with the remote control:
• Switch off the remote control and the helicopter.
• The plug for the charge cable is located on the back of the remote control (4D).
Remove the cover and then carefully plug the cable into the charge socket of the
helicopter (4E). The plug must be gently inserted into the charging socket –
DO NOT USE FORCE. If the plug is not correctly inserted into the charging socket,
the helicopter may become damaged and, under certain circumstances, become
an injury risk. Switch on the remote; the power LED blinks red. Slowly move the
thrust controller (2B) to maximum and then back to its starting position to acti­
vate the remote control; the power LED will begin to blink quickly. This process
lasts for approx. 3 seconds. Now the LED continuously illuminates green.
• The charging process is complete as soon as the LED is illuminated red.
• After the charging process, switch the power switch to „OFF" and disconnect
the charge cable from the helicopter.
The thrust controller (2B) must point down before being switched on (5A). Then
set the remote control's ON/OFF switch (2A) to „ON" (5B). The power LED begins
to blink. Now set the helicopter's ON/OFF switch (1F) to the „ON" (5C). Place the
helicopter on the ground so that the tail points toward you (5D).
Activate the remote control by slowly moving the thrust controller to maximum
and then back to its starting position; the power LED will begin to blink quickly.
This process lasts for approx. 3 seconds. The helicopter is ready to start when the
headlamp is permanently illuminated red.
4 CHARGING THE HELICOPTER
5 START PREPARATION
17