Revell Control TECHNIK NIGHT FLASH Manual De Usuario página 18

The­correct­trimming­is­a­basic­requirement­for­achieving­fault-free­flying­from­the­
helicopter. Its adjustment is simple, but it requires some patience and a feel for it.
Please observe the following instructions precisely: Carefully move the thrust cont­
roller (2B) up and raise the helicopter approximately 0.5 to 1 metre in altitude.
6A If the helicopter quickly or slowly rotates clockwise by itself...
If the helicopter begins to automatically rotate clockwise, rotate the trim adjust­
ment (2D) anti­clockwise until the helicopter no longer rotates on its own.
6B If the helicopter quickly or slowly rotates anti-clockwise by itself...
If the helicopter begins to automatically rotate anti­clockwise, rotate the trim
adjustment (2D) clockwise until the helicopter no longer rotates on its own.
Note: Only minimal corrections of the controls are necessary for a smoothing
flying­behaviour­of­the­helicopter!
7A Take off or increase altitude by carefully moving the thrust controller (2B)
forward.
7B Land or decrease altitude by moving the thrust controller (2B) backward. Only
minimal corrections to the controller are necessary to ensure smoothing flying
of the helicopter!
7C Fly forward by moving the controller for forward/backward flight and right/
left rotation (2E) carefully forward.
7D Fly backward by moving the controller for forward/backward flight and right/
left rotation (2E) carefully backward.
7E Turn the helicopter around anti­clockwise by moving the controller for forward/
backward flight and right/left rotation (2E) to the left.
7F Turn the helicopter around clockwise by moving the controller for forward/
backward flight and right/left rotation (2E) to the right.
7G Use button (2F) to switch the LED in the fuselage on and off.
18
6 TRIM ADJUSTMENT OF THE CONTROL
7 FLIGHT CONTROL