Timex IRONMAN TRANSIT+ Guia Del Usuario página 6

Timer Setting Mode
1. Press button C (Mode) until the mode prompt shows "TIMR".
2. Press and hold button A (Set/Indiglo) to enter the Loop Timer Setting mode.
3. Press B (Start/Stop/+) or D (Reset/Lap/-) to select SEG 1-6.
4. Press button C (Mode) to set Timer Second. Press B (Start/Stop/+) or D (Reset/Lap/-) to adjust to your
desired "Second" setting.
5. Press button C (Mode) to set Timer Minute. Press B (Start/Stop/+) or D (Reset/Lap/-) to adjust to your
desired "Minute" setting.
6. Press button C (Mode) to set Timer Hour. Press B (Start/Stop/+) or D (Reset/Lap/-) to adjust to your
desired "Hour" setting.
7. Press and hold button A (Set/Indiglo) to exit the setting mode.
The timer alert beep sound will be generated when each timer counts down to zero. Next segment of the timer
will be loaded and start to count down automatically. The number of loops is 20. Timer will stop automatically.
DAILY ALARM MODE:
Press button C (Mode) until the mode prompt shows "ALRM". The Alarm-1
prompt "AL-1" will be displayed at the upper row. The alarm time is displayed
at the lower row.
Press button D (Reset/Lap/-) to select Alarm-1 (AL-1), Alarm-2 (AL-2) and
Chime (Hourly chime function).
Press button B (Start/Stop/+) to turn the function on / off. If alarm is turned
on, "on" will be displayed at the bottom right corner. If "--" is displayed, the
alarm is turned off.
Alarm Setting Mode
1. In Alarm mode, press and hold button A to enter the Alarm Time
Setting mode.
2. Press button B (Start/Stop/+) or D (Reset/Lap/-) to select AL-1 or AL-2.
3. Press button C (Mode) to select the Hour or Minute setting.
4. Press button B (Start/Stop/+) or D (Reset/Lap/-) to change the selected setting digits.
5. Press and hold button A (Set/Indiglo) again to exit the setting mode.
Press any button while alarm sound is active to turn off the sound alert.
INDIGLO® night-light:
The watch provides INDIGLO® backlight for reading the display in dark environments. Press button A in any
mode to turn on the backlight. It lights up the display for 3 seconds.
BATTERY:
The watch operates with a 3V CR2032 battery. Below are some instruction for using and changing battery.
• Never expose the battery to excessive heat such as sunlight, fire or the like.
• Do not short-circuit the battery and do not take it apart.
• If necessary, clean the battery and unit contacts before inserting the battery.
• Dead batteries should be immediately removed from the device.
• Only replace the battery with a 3V CR2032 battery.
5