Getting Started; Handle Assembly - STACK-ON TDS-42-SG-E-S Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GETTING STARTED

To open the safe for the first time, remove the
spoke handle that is included in the instruction
sheet bag and screw it into the hub and
hand tighten.
NOTE: Do not use this handle to move the safe.
Remove the key from instruction sheet bag
and follow the steps below:
1. Remove the lock face by pressing the tab
and turning it as shown in the illustration.
The lock can hang by the connecting cable while
unlocking the safe.
2. Insert the key in the key hole and turn
clockwise 1/4 turn (until stopped) in order
to unlock the safe. Rotate the handle and
open the door.

HANDLE ASSEMBLY

Screw the 4 remaining handle spokes into the
hub and hand tighten.
NOTE: Do not use this handle to move the safe.
TAB
ELECTRONIC LOCK
Before you can enter any numbers, touch any
key on the keypad to activate it. The keypad
will stay illuminated for approximately
10 seconds.
After installing the battery, to open the
electronic lock the first time, first press any key
to activate the keypad, then press the following
numbers/symbols on the electronic keypad in
this order: 1 - 5 - 9 - #. These numbers
are preset.
NOTE: You should change the entry code as
soon as possible after opening the safe to
insure proper security.
After you have entered the factory code, you
will need to turn the handle clockwise to open
the door. You will have 5 seconds to turn the
handle before the locking mechanism
is reactivated.
NOTE: The red reset button located
on the inside of the door, is covered
with a removable red cap. When you
use the red reset button while setting
your own combination, remove the cap
to access the button.
Replace the cap securely over the reset
button after setting your combination.
Failure to do so will compromise the safety
and security of the safe.
2
14
40828-1806

Publicidad

Tabla de contenido
loading

Tabla de contenido