Getting Started; Installing The Batteries - STACK-ON QAS-450 Manual De Instrucciones

GETTING STARTED

When you first receive your safe you will need to
open the door with the key in order to install the
batteries. Batteries are included and are located
inside the safe.
NOTE: This key has also been provided in case you
lose or forget your security code or the batteries run
low. If you lose your key, you may purchase a
replacement key by referencing the serial number
located on the front of the door. See section
regarding replacement keys for further information.
To open the safe, insert key into lock and turn
clockwise until the door automatically opens.
NOTE: You must turn the key back to the locked
position before you are able to close and lock the
door.

INSTALLING THE BATTERIES

NOTE: Do not mix old and new batteries. Do not
mix alkaline, standard or rechargeable batteries.
Push the battery cover locking tab with a screwdriver
to release the cover. Install the (4) AA alkaline
batteries as shown. Replace the cover by inserting
the rear tabs in the slots and snapping the cover in
place.
NOTE: If the batteries are low the red light will
go on while the safe is opening. Replace with 4
new AA alkaline batteries as shown.
NOTE: For security you must reprogam your
combination after you change batteries.
2
18
40286-1307