KDP3 360
Presence detector
Fixing lens shield: There is circular hook on the back of the decorative frame
and the lens shield is designed with a circular groove. The lens shield can be
fitted by joining the groove of lens shield with its corresponding hook on the
decorative frame (See FIG.23-A & FIG.23-B).
Walk test (Lux setting is invalid)
The purpose of conducting the walk test is to check and adjust the detection
coverage. Set Time / Time1 knob to "Test", then conducting a walk test.
Note
It takes approx. 60sec for detector to warm
up after power is supplied, then enters into
normal operation to carry out a walk test.
Instructions manual |
Circular
groove
Circular
hook
FIG.23-A
Decorative frame
FIG.23-B
34
FIG.24
www.grupotemper.com