Sleep Mode - Orbegozo FDI 94 Manual De Instalación

FDI 94 FDI 124 FDI 184 FDI 244 MANUAL DE USUARIO

Be careful to not cause damage to the louvers.
Warning

Do not operate the air conditioner for long periods with the air flow direction set downward in cooling or
dehumidifying mode. Otherwise, condensation may occur on the surface of the horizontal louver causing
moisture to drop on to the floor or on furnishings.

Do not move the horizontal louver manually unless it is necessary. Always use the remote controller. If the
louver does not work, stop immediately the unit and start it again.

Open angle of the horizontal louver should not be set too small, as COOLING or HEATING performance may
be impaired due to too restricted air flow area.

SLEEP MODE

The SLEEP function is used to decrease energy use while you sleep (and don't need the same temperature settings to
stay comfortable). This function can only be activated via remote control.
Press the SLEEP button when you are ready to go to sleep.
- When in COOL mode, the unit will increase the temperature by 1°C (2°F) after 1 hour, and will increase an
additional 1°C (2°F) after another hour.
- When in HEAT mode, the unit will decrease the temperature by 1°C (2°F) after 1 hour, and will decrease an
additional 1°C (2°F) after another hour. It will hold the new temperature for 7 hours, then the unit will turn off
automatically.
Note: The SLEEP function is not available in FAN or DRY mode.
21