Bobrick SureFlo Instrucciones De Instalación página 4

6. Place double sided adhesive tape on top of back bracket and remove protective strip
from adhesive.
7. Without lowering the back of the cabinet. Place Cabinet on front Bracket aligning weld
studs on bottom of cabinet through holes in front bracket and gently place back of
cabinet on the back bracket which has the adhesive tape.
8. Place 2 lock washers and 2 hex nuts supplied on the weld studs on bottom of cabinet
and tighten to secure cabinet to front bracket.
9. To secure cabinet to wall, insert 5th Toggle Bolt head through key hole located at top
side of cabinet. Slide bolt head through top of keyhole and tighten.
10. Hook up. Low Soap Indicator (LSI) Light.
Connect two "C" sized batteries (supplied) to battery connector. Place clear lens
through the hole from outside of cabinet. Insert Black retaining ring on clear lens.
Insert LED (Red Light) from the inside, through the retainer ring into clear lens.
Note: Red LED Light should flash when the batteries are connected. LED light will
stop flashing when reservoir bladder is filled with soap. (Red light may flash for 3-6
hours after SureFlo soap cartridge is connected.)
Form No. 830-569 r11/13/12
Page 4
Cabinet Installation cont'd
S/F © 2018 Bobrick Washroom Equipment, Inc.
5 th
Mounting
Hole
Adhesive Tape
Weld Studs
Lock Washers
Hex Nuts
Cabinet Front
Weld Studs
Lock Washers
Hex Nuts
5th Mounting Hole
Lens
Side Wall of Cabinet
Retaining Ring
Printed in U.S.A.
LED Light