Descargar Imprimir esta página

Cosatto HOLD Manual Del Usuario página 5

Ocultar thumbs Ver también para HOLD:

Publicidad

Idiomas disponibles

Idiomas disponibles

operation:
1 - list of parts
1. Child car seat
2. Hood
3. Child car seat liner
4. Child car seat fabric cover
5. Chest Pads (x2)
6. Crotch Pad
7. Raincover
2 - approved seatbelt requirement
IMPORTANT: Never use the child car seat on a seat where an airbag is fitted and
active. Refer to your vehicle user manual for information on de-activating the
airbag.
WARNING: Your child car seat can only be installed rearward facing using a
three point lap and diagonal belt in the front or rear passenger seats of the car.
3 - general harness adjustment
It is recommended to adjust the harness length to fit your child, before installing the
child car seat into the car.
To tighten the shoulder straps, pull the webbing at the end of the system (a) until
achieving the fit and tension required.
To loosen off the shoulder straps push inwards the release catch under the flap (b)
and pull forward the shoulder straps (c) with the other hand keeping the catch pushed
down. Releasing the catch will secure the harness in place.
NOTE: The harness must be reasonably tight. It should restrain but not make the child
uncomfortable.
Check that the straps are not twisted while the child is seated.
4 - fastening harness buckle
Fit the two shoulder strap buckle parts together (a) and push into the crotch fitting (b)
until a firm click is heard. To open press the RED button (c).
5 - adjusting the shoulder strap and crotch strap position
The shoulder straps must be threaded through the slots in the child seat liner, child seat
cover and the child seat shell nearest the top of the child shoulders. If in any doubt
always use the slot above the shoulder rather than below it.
Loosen off the shoulder straps push inwards the release catch under the flap (a) and pull
forward the shoulder straps (b). Remove the shoulder straps off the harness
connector (c) at the rear of the seat.
Pull the child seat liner forward and pull the ends of the shoulder straps through the
slots in the seat (d).
There are four height positions for the shoulder straps. Push the ends of the shoulder
a. Handle
b. Handle adjustment button
c. Belt guide

Publicidad

loading