Phono & Encoding - auna Challenger LP Manual Del Usaurio

EN
18
PHONO & ENCODING
Notes
• Remove the stylus protector.
• Be sure that the tone arm is being detached from the tone arm rest
before operating and re-secured again afterwards.
Press function button repeatedly to select phono mode, phono indicator
will be light on.
Set the speed selector to the proper position depending on the record to be
played.
Place the record on the platter, use the 45 rpm adaptor if required.
Push the lift lever upward to raise the tone arm from the arm park, and then
slowly move it to the record side. The platter will start to rotate.
Put down the lift lever to drop the tone arm and touch the record
gently. Phono playing starts now.
Push the lift lever upward to raise the tone arm from the arm park, now
platter will still be rotating but phono playing will stop. To continue the
playing, the user needs to put down the lift lever.
Adjust the volume to the desired level.
At the end of record, the platter will automatically stop rotating. Push the
lift lever upward to raise the tone arm and move it to the arm park, and then
put down the lift lever.
To stop manually, lift the tone arm from the record and return it to the arm
park.
Remark : as some kind of record the auto-stop area was out of the unit
setting, so it will stop before the last track finishes. In this case, select the
auto-stop switch to " off " position, then it will run to the end of the record
but will not stop automatically (turn off the unit by power button or switch
back the auto-stop switch to " on " position to stop the platter rotate). Then
put back the tone arm to the arm park.
Phono encoding
Before switch on the unit, insert USB memory device to USB slot.
Press standby button to switch on the unit, then select phono mode.
Press the REC button, then the phono indicator will be flashing.
To finish encoding, press REC button again, then the unit will switch to USB
mode and play the previous recorded track.
Remark:
The recording speed is 1:1 and according to the actual playing time of the
phono.
The recording format is preset at – MP3 bit rate : 128 kbps
Do not unplug the USB device during recording.