Care And Cleaning; Troubleshooting - Kreg KMA4000 Manual Del Propietário

2
Use the Crosscut Guide to Cut Your Workpiece
a. Mark your workpiece to your desired length.
b. Place the crosscut guide on the workpiece. Extend and hold the 90° thumb lever (D) all the
way to the stop.
c. Align the 90° cut line indicator (A) to the mark on the workpiece, then release the 90° thumb
lever (D) while still holding the crosscut guide in place to retract the 90° cut line indicator (A).
d. Align your saw to the 90° saw guide edge (F) and cut the workpiece to your desired length.
e. To cut at a 45° angle, repeat this procedure for the 45° side of the crosscut guide.
D

Care and Cleaning

Keep SureGrip™ surfaces clean of dust and debris.

Troubleshooting

Problem
The cut line is not accurate.
The cut line indicator(s) do not
retract or stick.
The cut is not accurate.
A
Possible Cause
The cut line indicator moved.
The slide mechanism has debris
impeding the cut line indicator
movement.
The saw blade is not parallel to the
edge of the saw base.
The cut line indicators have been
knocked out of calibration.
Solution
Recalibrate the guide.
Use compressed air or an air
compressor to blow the debris
from the slide mechanism.
See the saw owner's manual.
Refer to the calibration procedure
in this manual.
F
5