Electric Installation - Electrolux 56SB Manual De Instrucciones

IMPORTANT
Always use a pressure regulator to any type of
gas cylinder. Its absence can cause excess of
gas pressure and leaks. Check the expiry date
of the pressure regulator and hose.
Use PVC plastic hose with yellow stripes, since:
- The hose has no amendment;
- Do not cross behind the cooker and not pass
next to hot air outlets or cross through the wall;
- The length of the hose is less than 125 cm;
- The hose is within the expiry date.
If the resistance is supplied with gas cylinder,
check the distance between it and the cooker.
If the 125 cm plastic hose is not long enough
to connect the cooker to the gas cylinder, use
steel or copper pipes for the connection.
If the gas inlet is arranged so that the hose
cross the back of the cooker, use a 1/2" flexible
metal hose with an adapter to connect it to the
cooker.
In the case of piped gas, the use of flexible
metal hose and adapter is recommended; you
can also use plastic hose since it does not
cross the back of the cooker.
Do not use plastic hose coated with metal, as it
offers the same risk as plastic hose.
If in doubt during acquisition of accessories for
installing the product, call the Service Station.

Electric installation

For your safety ask to an electrician
to check the condition of the electric
network of the installation place or
o contact the Electrolux Service
Station. Our products leave the
factory into 220V;
before connecting, check the
voltage of the plug and turn the selector switch
located on the back of the appliance into 127V
or 220V position, according to the voltage in
your home. These models require a special three-
pin connector with an exclusive circuit breaker (see
page 40).
30
All manuals and user guides at all-guides.com
therefore,
Before connecting, be sure:
- The plug or circuit breaker used for connection
are easily accessible, even after having installed
the cooker;
- The power cord must be so never touch the hot
walls of the cooker, as they can melt the electrical
insulation and cause short circuit;
- Do not use extensions or connectors;
- Never connect the ground wire to gas or PVC
pipes;
- Properly install the ground wire of your cooker
according to local regulations;
- Check if the lamp voltage agrees with the mains
and replace if necessary;
- It's necessary to change the lamp to 127V
electrical network;
- If in doubt, consult an electrician.
Voltage Minimum
Ground wire
If your cooker has a ground wire (green or green/
yellow) near the power cable, it must be connected
to a suitable grounding point.
Do not connect the ground wire to taps, water,
electric or gas pipelines or to the network neutral
cable.
If your product has a 3 pin plug, use the appropriate
grounding plug. You must not cut grounding pin of
the plug. For your safety, ask an electrician to install
the ground wire in your residence.
Maximum