Publicidad
Idiomas disponibles
Idiomas disponibles
ADVICE FOR INSTALLATION
3
A 10 cm thick 350-kg/m
concrete slab is required for securing the bolts.
The bolts are to be attached to a level surface (pavement). Do not attach them to the coping (except
when blocking the module used in case of steps along the length).
Before you start the operation, practice using the ratchets (tightening and releasing).
In addition, we propose protective strips ref. 100891 to place on the lengths of the pool to
limit wear of the cover and marking of curbstones
INSTALLATION
YOU ARE ADVISED TO READ ALL THE STEPS IN THE INSTALLATION
PROCEDURE BEFORE PUTTING THE COVER INTO POSITION, IN ORDER TO
AVOID ANY UNNECESSARY OPERATIONS.
STEP 1
Choosing the storage side
Position the cover along the length of the swimming pool on the storage side (with the cover rolled up),
beige colour downwards.
When there are steps along the length of the pool, the storage side will be on the side opposite the steps.
Slide the cover carefully out of the tube it was packed in (protecting it from the ground if necessary).
STEP 2
Only for pools with steps along the length of the swimming pool
(sang
Position the step module along the length on the step side (with the cover rolled up), beige colour
downwards.
Insert the coping supports into the slides on each side of the tube. The plastic part will be resting on the
coping elements.
Mark the points where the holes are to be drilled on each side of the steps 8 centimetres from the edge
of the coping (inside pool).
8 cm
8 cm
8 cm
8 cm
Drill a 10 mm diameter, 80 mm deep hole at a 45° angle.
NOTCOUVEGA – ind F FRGBSP
12 / 24
Publicidad
