Key Automation 900CT-101 Manual De Instrucciones página 37

DISPLAY DATA
StoP
no
ProS
invE
Foto
CFCh
no
Ch
tESt
no
Ft.Co
CoSt
Foto
CoSt
no
rESi
StAn
AP.Ch
Ch
AP
FC.En
StoP
no
rALL
ASM 0.5" ÷ 2.0'
no
SEnS 0 ÷ 10
Cont
tot.
SErv
APPr
no
Go
FinE
no
Si
900CT-101 FUNCTION TABLE
DESCRIPTION
STOP input
- STOP input not available
- STOP command stops the gate: START command starts moving in the
opposite direction
- STOP command stops the gate: pressing the START command gate continues
the motion
PHOTO 2 input
- Photocell is active in closing and also when the gate is still
- Not available
- Photocell is active during the closing
Test of safety devices
- Function not active
- Test enabled only for photocells
- Test enabled only for safety edges
- Test enabled either for photocells or for safety edges
Border input
- Input disabled (the control unit ignores it)
- Input enabled for conductive rubber ribbons
- Input enabled for standard safety ribbons with normally closed contact
- Input enabled in opening and closing phase
- Input enabled only in opening phase
- Input enabled only in closing phase
End of stroke inputs
- Input disabled (the control unit ignores it)
- Inputs enabled: the gate starts the slowdown phase (menu t.rAL) near
the limit switches
- Input enabled: the gate stops near the limit switches
Anti-skid
- Function disabled
Obstacle sensor level
Counter viewing
- Total number of completed cycles (views in thousands or in units)
- Number of cycles before the next request for service (such a number has
been rounded off to hundreds and it can be set up on 1000-step; in
case it is set up on 0, the request will be disabled and no will be viewed)
Automatic learning of the operation time
- Function disabled
- Start up of the automatic learning procedure
End of programming
- It does not exit from the program menu
- It exits from the program menu by storing the setup parameters
35
MEMO
DEFAULT
DATA
no
CFCh
no
no
StoP
1.0"
5
tot
no
no