KENMORE ELITE PreView Grab-N-Go Manual De Uso Y Cuidado página 46

Problem
Icemaker is not Refrigerator was recently installed or
making ice. icemaker recently connected.
Icemaker not turned on.
The refrigerator is not connected to
valve is not turned on.
obstructed.
system is connected to your cold
water supply.
Not dispensing water. New installation or water line recently
connected.
The dispenser panel is locked.
The dispenser is not set for water
dispensing.
Refrigerator or freezer doors are not
closed properly.
removed or replaced.
Tubing connecting refrigerator to
house supply valve is kinked.
The house water supply is not
connected, the valve is not turned on
fully, or the valve is clogged.
Possible Causes
46
Solutions
It may take up to 24 hours for each compartment to
reach the desired temperature and for the icemaker to
begin making ice.
Locate the icemaker ON/OFF
it is turned ON.
Connect refrigerator to the water supply and turn the
make sure that the arm moves freely.
water pressure below the minimum amount and result
from the system. Do not dispense the entire 2.5
gallon amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
Press and hold the Lock button for three seconds to
unlock the control panel and dispenser.
The dispenser can be set for ice or water. Make
certain that the control panel is set for the proper
operation. Press the Water button on the control panel
to dispense water.
Water will not dispense if any of the refrigerator
doors are left open.
trapped air and contaminates from the system. Do not
dispense the entire 2.5 gallon amount continuously.
Depress and release the dispenser pad for cycles of
30 seconds ON and 60 seconds OFF.
The tubing can kink when the refrigerator is moved
during installation or cleaning resulting in reduced
and arrange it to prevent future kinks.
Connect refrigerator to the water supply and turn the
If the problem persists, it may be necessary to contact
a plumber.
Water Pressure