Seatpost Assembly - Cervélo S3 Manual De Montaje

SEATPOST ASSEMBLY

1. Ensure Loctite 242 is applied to threads
below the head of the 45 mm button
head cap screw. Install cross bar on
45 mm button head cap screw and
torque to 3 Nm.
2. Ensure Loctite 242 is applied to both
fixing screw threads.
3. Install the curved washer and
adjustment dial in the seatpost cutout.
4. Install the button head cap screw with
crossbar installed, and turn the dial
until threads are engaged.
5. Install the spherical washer on the
35 mm spherical cap screw, so that the
concave face, mates with the convex
surface of the screw.
6. Install cross bar.
7. Apply light coat of carbon assembly
compound to the radius on the upper
face of the seatpost.
8. Install the lower saddle clamp base, as
per the diagram.
9. Locate saddle rails between upper and
lower clamping surfaces.
10. Establish desired saddle angle by first
using adjustment wheel.
11. Tighten opposing angle adjusting
screw to secure saddle at 8-9 Nm.
27
Adjustment
Wheel
0 mm Offset Seatpost
(SP-SP20-ZERO)
M5 Seatpost
Fixing Screws
Actual Size
Button Head
Cap Screw
M5 X 45
Crossbar
Saddle Clamp
Base
Spherical
Cap Screw
M5 X 35
25 mm Offset Seatpost
(SP-SP20-25 MM)
35 mm
45 mm
Spherical
Cap Screw
M5 X 35
Button Head
Cap Screw
M5 X 45
Adjustment
Wheel
NOTE: The S Series
seatpost is compatible
with both metallic
saddle rails (7 mm
diameter) and carbon
saddle rails (7x9 mm
cross section).