Operation; Layout Of The Front And Rear Panel - GALAGAR SMART CUT 1000 Manual Técnico De Instrucciones

4. 4. 4. 4. OPERATION

OPERATION OPERATION OPERATION
4.1

4.1 Layout Of The Front And Rear Panel

4.1 4.1 Layout Of The Front And Rear Panel Layout Of The Front And Rear Panel Layout Of The Front And Rear Panel
1.Barometer 1.Barometer ensure there are no impurity and moisture in the compressed air
1.Barometer 1.Barometer
2. Power pilot lamp 2. Power pilot lamp 2. Power pilot lamp 2. Power pilot lamp
3.Cutting current regulator it is used to regulate the current when cutting. 3.Cutting current regulator
3.Cutting current regulator 3.Cutting current regulator
4.Over 4.Over- - - - current , over 4.Over 4.Over current , over current , over- - - - heat alarm current , over heat alarm when over-heat, over-current, the lamp would be on. heat alarm heat alarm
5.Cutting gun improper installation and air pressure low alarm 5.Cutting gun improper installation and air pressure low alarm 5.Cutting gun improper installation and air pressure low alarm 5.Cutting gun improper installation and air pressure low alarm
6. Work lamp 6. W ork lamp turn on the switch of the cutting gun, generate the voltage, the lamp on
6. W 6. W ork lamp ork lamp
7. 7. 7. 7. Normal Cut Normal Cut Normal Cut Normal Cut
Grid Cut Grid Cut Grid Cut Grid Cut
Note: When these two functions toggling, check gas for 10 seconds and then stop it. During this process, press and release the gun switch
quickly, gas check finishes.
8.Power switch 8.Power switch turn on or off the power source 8.Power switch 8.Power switch
9.Positive output cable connected to the workpiece 9.Positive output cable
9.Positive output cable 9.Positive output cable
10.remote control plug 10.remote control plug 10.remote control plug 10.remote control plug
11.Cutting gun connector connected to the cutting machine 11.Cutting gun connector
11.Cutting gun connector 11.Cutting gun connector
12.Power cable 12.Power cable connected to the appreciate power supply 12.Power cable 12.Power cable
13.fan cooling window 13.fan cooling window 13.fan cooling window 13.fan cooling window
14.Compressed air output connector 14.Compressed
14.Compressed 14.Compressed
SMART CUT 1000
Fig 4.1 schematic drawing of the front panel and rear panel
18