GALAGAR SMART CUT 1000 Manual Técnico De Instrucciones página 20

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.
Grid Cut
Automatic gas
Turn on the
test for 10S
power source
The current will
Yes
down to 40A
Cutting
Restart and continue
working
Finish after post-gas for 15s
Note:
Note:
Note:
Note:
1)
The alarm lamp on when cutting, it is needed to loose the switch of the torch until the alarm release, then press
on the switch to restart working.
2)
In the automatic gas test and examine, press on the cutting torch, there will no reflection.
3)
After a long usage, the surface of the electrode and nozzle will have Oxidation reaction. Please replace the
electrode and nozzle, For The alarm lamp will on when install the shield cup, and stop working
4)
It is forbidden to take down the fittings of the cutting torch when the trigger is pressed.
5)
If the cutting current is higher than 40A, when the tip touch the workpiece, the current will down to 40A in oder
to protect the tip.
6)
Among the period of post gas, if you press the trigger for a long time, the arc restars; if you press and loosen
the trigger quickly, the gas stops, after it you can press the trigger for a long time to restart the machine as well.
SMART CUT 1000
Automatic
examine for 5s
If the tip touch the
workpiece and the
current higher than
40A, isn't it ?
No
Yes
Is the torch trigger pressed on
again among the period of post-
No
gas ?
Fig 4.3 the working flow chart
After
Initialization and
the fan stop,
press on the torch
trigger
Shift to the workpiece,
the pilot arc change
into cutting arc
The torch move away
the workpiece, then the
cutting arc change into
the pilot arc
20
Pre-gas
for 1s
Ignite the
pilot arc, the
max. time
is10s
Loose the
cutting torch
trigger, the arc
stops
Post-gas

Publicidad

Tabla de contenido
loading

Tabla de contenido