COMENDA PC Serie Instrucciones Para El Uso Y El Mantenimiento página 15

Part 2: Reserved for the operator
2.1.c STARTING the WASH CYCLE
ATTENTION
I
t is recommended to check the level of detergent
and rinse agent daily.
IMPORTANT
The MANUAL or AUTOMATIC
(by closing the capote) cycle start-up mode must be
changed by an authorised technician.
STARTING the MANUAL WASH CYCLE
Press the START key
to start the wash cycle.
The START key turns BLUE
during the entire duration of the wash cycle.
The countdown of the cycle appears on the display in
seconds. Any other alarm messages will be displayed
on the right.
The following phases are performed during a complete
cycle:
° WASH
° PAUSE
° RINSE
° DRAIN
During the cycle you can
display the ACTUAL temperature
by pressing the BACK key.
THERMOSTOP FUNCTION
If the rinsing temperature is not ADEQUATE at the
end of the washing phase, the COUNTDOWN on the
display stops, so as to indicate the intervention of the
thermostop. The washing phase will last for as long as
is necessary to reach the MINIMUM GUARANTEED
RINSE temperature, equal to the value:
T°setpoint – set thermostop value.
Once the set temperature value is reached, the count-
down resumes until the cycle is completed.
Any other messages will be displayed on the right.
The pause to reach the ideal temperature can be pro-
longed to a maximum of 8 minutes.
After this time, the washing and rinsing cycle is com-
pleted and the H1 alarm will appear on the right side
of the display.
During the thermostop you can
display the ACTUAL temperature
by pressing the BACK key.
2.1.d INTERRUPTING the CYCLE
The wash cycle can be temporarily interrupted in
two ways:
1) F1 appears on the display
when the capote is opened.
When the capote is closed
again, the cycle resumes from where it stopped.
Once the wash cycle is com-
pleted, the SET temperatures
appear on the display.
The START key turns STEADY
GREEN (indicating that the
machine is ready for the next
START START
cycle).
At the end of the wash cycle, remove the dish rack
and shake it gently to remove the last drops on the
washed items.
Let the objects dry and remove them from the dish
rack with clean hands.
Set everything on hygienic and stable surfaces.
2) Turn off the machine by
keeping the START
key pressed for 5 sec.
This way, every active cycle
is interrupted defi nitely and the machine is set to
OFF.
When switched on again, the LED associated with
the last selected cycle will light up and the display
will indicate the alarm code "A1" that will disappear
when a new cycle begins.
2.1.e DRAINING WATER FROM THE TANK
2.1.e .1 MACHINE DRAIN
The water in the tank can be emptied at any time of
the day depending on the accumulated fi lth.
Proceed as follows to perform
this operation:
- SWITCH OFF the dishwasher
by pressing the START key for
5 sec.
- OFF appears on
the display.
- Remove the overfl ow (13),
allowing the water to drain com-
pletely from the tank;
- Extract the tank fi lter (14) and
clean it.
At the end of the cycle, put the fi lter (14) and the
overfl ow (13) back into the respective seats.
without a DRAIN PUMP (Fig. 8)
ENGLISH
START START
START START
START START
15