USING THE DEVICE
To use and configure the THERMARP thermostat, down-
load the instruction manual by scanning the following
QR Code with the camera of your smartphone or tablet.
INSTALLATION
HOW TO START THE THERMOSTAT
The YOKIS THERMARP thermostat runs on
batteries (2 x 1.5 V AAA / LR03 type batteries).
1. Open the rear compartment of the thermostat timer
to insert the batteries, checking the polarity indicated
on the battery compartment.
2. After the batteries have been inserted correctly,
the thermostat will display the following screen after about 20 seconds.
3. Do not connect the thermostat to the base until the previous screen is displayed.
Couple first the teeth on the top side.
No programming or changes can be made to the set parameters until the device
is properly attached to the wall base.
4. The clock must be set (by entering time and date) after the thermostat is powered.
The thermostat requires the time and date to be entered in order to operate
correctly.
5. Hold button
button
to access the time and date configuration.
DS1054-055A
pressed for 3 seconds until the clock icon
+
-
P14
GB
+
-
starts flashing. Press