Evolution R210CMS Instrucciones Originales página 13

www.evolutionpowertools.com
so positioned that it does not interfere with the path
of the blade or other moving machine parts.
• Avoid awkward operations and hand positions where a sudden
slip could cause your fingers or a hand to move into the blade.
• Before attempting a cut, make a 'dry run' with the power
off so that you can see the path of the blade.
• Keep your hands in position until the ON/OFF trigger switch has
been released and the blade has completely stopped.
ADJUSTMENT OF PRECISION ANGLES
(8.4)
Several checks/adjustments are possible on this machine.
The operator will require a 45°/45°/90° set square (not supplied) to
carry out these checks and adjustments.
WARNING: Checks/adjustments must only be conducted
with the machine disconnected from the power supply.
BEVEL ANGLES (0° & 45°)
0° Bevel Stop Adjustment
• Ensure that the cutting head is in the locked down position with
the latching pin fully engaged in its socket (see Fig.16).
• Ensure that the cutting head is upright, against its stop
and the bevel pointer is indicating 0° on the scale (Fig. 8).
• Place the set square on the table with one short edge against the
table and the other short edge against the blade (avoiding the
TCT tips of the blade teeth) (Fig. 9).
• If the blade is not at 90° (square) with the mitre table, adjustment
is required.
• Loosen the bevel locking handle and tilt the cutting head
to the left.
• Loosen the locknut on the bevel angle adjustment screw with a
10mm spanner and 3mm Hex key (Not supplied) (Fig. 10).
• Use the Hex key to turn the screw in or out to adjust the
blade angle.
• Return the cutting head to its upright position and
recheck the angular alignment against the set square.
• Repeat the above steps until correct angular alignment
is achieved.
• Tighten the bevel angle adjustment locknut securely.
45° Bevel Stop Adjustment
• Loosen the bevel locking handle and tilt the cutting head
completely to the left until it rests against the 45° stop.
• Use a set square (avoiding the TCT tips of the blade teeth), check
that the blade is at 45° to the table.
• If the saw blade is not in exact alignment adjustment
is necessary.
• Return the cutting head to its upright position.
• Loosen the locknut on the 45° bevel adjustment screw with a
10mm spanner and 3mm Hex key (Not supplied).
• Use the Hex key to adjust the adjustment screw in or out
as required (Fig. 11).
• Tilt the cutting head to the 45° setting and recheck for alignment
with the set square.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
13
EN