Transmitter - RF Player RF P1000 Manual De Usuario

TRANSMITTER

EN
You can transmit frames according to each protocol on 256 different channels. This tab is not useful
if you connect RFPLAYER to a home automation box or use RFPLAYER as a receiver.
The Transmitter tab is usually useful to make tests.
Note: While receivers need to adjust the frequency, this setting is unnecessary for the transmitter, the transmission frequency
being automatically dynamically adjusted according to the protocols.
SET THE DESIRED PROTOCOL.
Set the channel number by pseudo-address X10 A1 ... A16-P1 ... P16 or directly by number 0 ...
255.
Adjust the RF action to be executed: ON, OFF, DIM Etc. ... Then do «Transmit» to send the frame.
OTHER PARAMETERS (POSSIBILITY OF NOT SPECIFYING MOST CASES):
Burst: Size of the emitted RF burst. If omitted, 0 or 1, the burst is standard. Set 2, 3 or more to repeat
the burst of RADIO frames.
Qualifier: Specifying a frame variant. Set '1' for a «Portal» Somfy RTS frame and put '0' (or nothing)
for a «Shutter» frame.
DIM: Dimming value (example 40 for 40%) if the action is DIM.
Note: Initial pairing between a transmitter and a receiver is done by the ASSOC action. Afterwards,
it is possible to perform ON/OFF/DIM actions.
21
user guide RF P1000 v1.0 - www.rfplayer.com