No change in measurements with drain
shown. (K-7202)
1-3/16"
(3 cm)
25-11/16"
24-1/2"
(65.2 cm)
(62.2 cm)
Product Information
Applicable product:
Bath with airjets
Bath with airjets and chromatherapy
Fixture*:
Bathing well:
Basin area, bottom
Basin area, top
Weight
To overflow:
Water depth
Capacity
* Approximate measurements for comparison only.
Included components:
Cut-out template (for drop-in installations only) 1016369-7
Blower motor/
Heater
control:
300 W
Required accessories:
Undermount template kit (for undermount
installations only)
Bath drain
1038266-1-C
Blower/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H
K-1110-G
K-1110-GCR
45" (114.3 cm) x 25-1/2" (64.8 cm)
63" (160 cm) x 31-1/2" (80 cm)
134 lbs (60.8 kg)
21" (53.3 cm)
115 gal (435.3 L)
V
Hz
220-240 V
50/60
K-589
K-7202
46"
(116.8 cm)
1-3/8"
(3.5 cm)
6" (15.2 cm)
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Blower motor/control:
Notes
Install this product according to the installation guide.
NOTICE: If the blower motor and check valve are relocated, the
following two procedures are required: 1. Provide two access
panels. Locate one access panel at the blower motor/control
location and the other access panel at the control box. 2. Relocate
the blower motor and the check valve together. Do not relocate one
without the other.
Floor support under bath must provide for a minimum of 47 lbs
(228 kg).
Hot water supply should be 70% of capacity or greater.
Installations will vary.
This bath is designed for drop-in or undermount installation only.
It is not suited for use in a three-wall alcove with an overhead
A
shower.
3
Fixture dimensions are nominal and conform to tolerances in ANSI
Standard Z124.1.2.
2
K-1110-GCR
12-3/16"
(31 cm)
6"
(15.2 cm)
4" (10.2 cm)
3-3/8" (8.6 cm)
72" (182.9 cm)
7/16" (1.1 cm)
220-240 V, 15 A, 50/60 Hz
3-15/16"
(10 cm)
23"
(58.4 cm)
6-1/2"
(16.5 cm)
5-1/2"
(14 cm)
1-1/2" OD
Kohler Co.