Whittier Wood 589Wb Instrucciones Para Armar página 10

K
U
Q
R
FIG. 9A
9) Attach two Drawer Sides (K) to the Drawer False Front (P) with #8 x 1¼" Black Screws (U) through
the pre-drilled holes in the sides. The grooves for the Drawer Bottom must line up. Slide the Drawer
Bottom (Q) into the grooves. Attach the Drawer End (R) to the Sides in the same manner. See FIG-
URE 9A. Repeat the above steps for the other Drawer.
Square the drawers by measuring from left front to right rear and from right front to left rear. The
measurements should be equal. If one is longer, hold the drawer by the corners on the longest line
and squeeze them together until square. See FIGURE 9B.
FIG. 10
10) Attach Drawer Slides (Drawer Side Left) [N4] and (Drawer Side Right) [N3] to the drawers. The
wheels should be to the rear and the front edge should be fl ush with drawer side. Attach the slides
with three #6 x 5/8" Undercut Screws (Z). The slides will not reach the back of the drawer. See FIG-
URE 10.
Page 10 — 589Wb — Rev. 9/07
P
Z
N3
P
K
U
U
FIG. 9B
N4
Z