Tabla de contenido
Publicidad
6) Hammer the Tack Glides (ZG) into the side panels near the back. Measure up 3/4" from the bottom
of the unit on the back side of the base where it meets the side panel and draw a short line. Lay the
Corner Brace (ZA) so that its bottom edge is on the line and screw that brace to the base and side
panel with #8 x 5/8" Pan Head Screws (ZB). See FIGURE 6. Screw Adjustable Glides (Y) into corner
braces.
FIG. 7
7) Attach the Hinges (W) to the Doors (J) with #6 x 5/8" Undercut (type 17) Screws (Z). The outermost
hole in the hinge must go over the pre-punched hole in the door.
Attach the Knob (ZX) using the #8 x 1" Machine Screw (ZF).
Page 8 — 589Wb — Rev. 9/07
FIG. 6
J
ZG
ZG
3/4"
W
ZA
ZB
ZB
Z
Y
Publicidad
Tabla de contenido
