Tools Required - Whittier Wood 589Wb Instrucciones Para Armar

589Wb Palmer Wardrobe/Media Center
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Head Screwdriver, Tape Measure, Hammer, Wood Glue,
Ab
N 2
N 2
READ THE CAM LOCK SYSTEM INSTRUCTIONS ON THE ENCLOSED
SHEET AT THIS TIME.
1) Install Drawer Slides using #6 x 5/8" Undercut Screws (Z) in the two pre-punched holes in the
following pieces:
Two Drawer Slides (Cabinet Side Right) [N1] on the Right Side (Bb)
Two Drawer Slides (Cabinet Side Left) [N2] on the Left Side (Ab)
Insert a third screw in one of the center holes in each of the slides. See FIGURE 1. The drawer
slides will be slightly back from the front edge.
Install Cam Connectors (L) in the pre-drilled holes in the following pieces:
Two in the Left Side (Ab)
Two in the Right Side (Bb)
3/16" Drill Bit and Drill.
FIG. 1
L
L
Z
Z
Z
Z
STAIN TEST AREA
Bb
The side panels have a
compression stamp on the
"L" for left, "R" for right.
N 1
N 1
bottom edge:
The drawer slides will be
stamped with an "L" for left or
an "R" for right in the center
of the wheels. Or they will be
stamped about 3" from the
wheel with: "CL" for cabinet
Left; "DL" for drawer left; "CR"
for cabinet right; "DR" for
drawer right.
Rev. 9/07 — 589Wb — Page 5