STERWINS 1000 DWP CE 8I-3 Manual Del Usuario página 153

Attach a sufficiently long rope to the suspension rings before first use.
Risk of damage to the appliance!
Never lift the pump by the power cable or the discharge hose as these are
not designed to bear the weight of the pump.
Attention!
Note:
Use a sufficiently strong rope which is resistant to water and to UV
radiation. If the rope is to be permanently attached to the pump, the
condition of the rope must be checked regularly as it could decay and
break over time.
Connecting the discharge hose/pipe
For occasional use, use a suitable water hose.
The use of rigid pipes with a non-return valve is recommended for use at a fixed location.
This prevents return flow of the liquid when switching off.
• Screw the discharge line onto the discharge connector.
All threaded connections must be sealed with thread sealing tape (e. g. Teflon® tape).
• When using a hose, screw a suitable hose adapter onto the discharge connector.
• Push the hose firmly onto the hose adapter and secure with a hose clamp.
Installation
Risk of damage to the appliance!
Do not place the device on the bottom of the well It must be suspended
in the water at least 1m above the bottom of the well.
The device is not suitable for use in sandy water. If the well is sandy, it
Attention!
must be cleaned in advance to prevent silting. The warranty will be void
if the damage is caused by silted water.
153
PREPARATION
EN