Cleaning And Maintenance - STERWINS 1000 DWP CE 8I-3 Manual Del Usuario

Risk of damage to the appliance!
Do not allow the appliance to run without water
Attention!
• Switch on the pump at the On/Off switch (8).
Overload protection
The appliance is equipped with overload protection.
This switches the motor off if it is overloaded.
If the overload protection was triggered:
1. Eliminate the cause of the overload
2. Press the motor protection switch (7).

Cleaning and maintenance

Cleaning and maintenance overview
Before lowering into the pump shaft
What?
Check housing, discharge hose, and cable for damage
After removal from the pump shaft
What?
Clean the appliance.
C leaning the appliance externally
Rinse with clean water. Remove stubborn contamination with a brush and detergent.
Submerge the pump in a container with clean water and switch on for a short time to rinse
the inside of the pump.
Note:
Before using the pump again, first "soak" it so that any possible dirt
residues do not block the appliance.
How?
Visual inspection.
How?
155
OPERATION
EN