Programming - Vimar ELVOX RS11 Manual De Instalación Y Funcionamiento

7- Programming

Rapid procedures for learning the travel for automatic gate systems with double swing leaves, with slowdown.
The reduced procedures allow learning only the distances for slowing down, while the gate leaf delays are fixed at 2 sec for opening and 4 sec for closing.
WITH SLOWDOWN
- Close the gate fully.
- Press and hold learning pushbutton P1 for at least 3 seconds
- The DL8 LED starts flashing slowly
- Release pushbutton P1
- Activate APCH: The first gate leaf opens at normal speed
- When you want the gate to move more slowly activate APCH
- The slow speed phase begins for motor M1.
- When the gate leaf reaches full opening activate APCH: the second leaf will open at normal speed
- When you want the gate to move more slowly activate APCH
- The slow speed phase begins for motor M2.
- When the gate leaf reaches full opening activate APCH: the second leaf will start closing at normal speed
- When you want the gate to move more slowly activate APCH
- The slow speed phase begins for motor M2.
- When the gate leaf reaches full closure activate APCH: the first leaf will start closing at normal speed
- When you want the gate to move more slowly activate APCH
- The slow speed phase begins for motor M1.
- When the gate leaf reaches full closure activate APCH
- Wait for the DL8 LED to switch off.
- Learning successfully completed.
Rapid procedures for learning the travel for automatic gate systems with double swing leaves, without slowdown.
Fully adjust the trimmer TR4-V.RALL
- Close the gate fully.
- Press and hold learning pushbutton P1 for at least 3 seconds
- The DL8 LED starts flashing slowly
- Release pushbutton P1
- Activate APCH: The first gate leaf opens at normal speed
- When the gate leaf reaches full opening activate APCH: the second leaf will open at normal speed
- When the gate leaf reaches full opening activate APCH: the second leaf will start closing at normal speed
- When the gate leaf reaches full closure activate APCH: the first leaf will start closing at normal speed
- When the gate leaf reaches full closure activate APCH
- Wait for the DL8 LED to switch off.
- Learning successfully completed.
Complete procedures for learning the travel for automatic gate systems with double swing leaves, with slowdown.
The complete procedures permit learning the gate leaf delays too
WITH SLOWDOWN
- Close the gate fully.
- Press and hold learning pushbutton P1 for at least 3 seconds
- The DL8 LED starts flashing
- Do not release the P1 button and hold it down for 3 seconds
- The DL8 LED starts flashing faster
- Release pushbutton P1
- Activate APCH: The first gate leaf opens at normal speed
- When you want the gate to move more slowly activate APCH
- The slow speed phase begins for motor M1.
- When the gate leaf reaches full opening activate APCH: the second leaf will open at normal speed
- When you want the gate to move more slowly activate APCH
- The slow speed phase begins for motor M2.
- When the gate leaf reaches full opening activate APCH: the second leaf will start closing at normal speed
- When you want the gate to move more slowly activate APCH
- The slow speed phase begins for motor M2.
- When the gate leaf reaches full closure activate APCH: the first leaf will start closing at normal speed
- When you want the gate to move more slowly activate APCH
- The slow speed phase begins for motor M1.
- When the gate leaf reaches full closure activate APCH
- Activate APCH: the first gate leaf starts opening and as soon as you decide that the gate leaf offset time is enough, activate APCH again: the second gate
leaf will start opening.
- Activate APCH: the second gate leaf starts closing and as soon as you decide that the gate leaf offset time is enough, activate APCH again: the first gate
leaf will start closing.
- Wait for the DL8 LED to switch off
- Learning successfully completed.
EN
(clockwise)
21