Riving Knife - Festool TS 75 EQ Manual De Instrucciones Original

Colour Material
Yellow Wood
Red Laminate, mineral ma­
terial
Green Plaster- and cement-
bonded chipboard and
fibreboard
Blue Aluminium, plastic
8.5 Changing the saw blade
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
Remove the saw blade
► Swivel the machine to 0° before replacing
the saw blade and adjust the maximum cut­
ting depth.
► Turn the lever [6.2] as far as it will go.
► Slide the safety lock [6.1] upwards and
push the saw unit downwards until it clicks
into place.
► Loosen the screw [6.4] using the Allen
key [6.3].
► Remove the saw blade [6.7].
Inserting the saw blade
WARNING! Check the screws and flange for
contamination and only use clean and undam­
aged parts.
► Insert the new saw blade.
WARNING! The direction of rotation of the
saw blade [6.7] and saw [6.5] must match.
Serious injuries may occur in the event of
non-compliance.
► Insert the outer flange [6.8] so that the pin
engages in the recess on the inner flange.
► Tighten the screw [6.4].
► Reposition the lever [6.2].
Symbol
HPL/TRESPA ®
6.4
6.7
6.8
8.6
Risk of injury
The circular saw is fitted with a riving
knife [7.1] as standard. All saw work should,
for safety reasons, only be carried out with
the riving knife installed and correctly set
The riving knife must be set so that
–
–
6.5
6.6

Riving knife

WARNING
7.1 7.2
the distance between riving knife and cut­
ting circle [7.2] of the saw blade is 5/64" to
5/32" (2 - 4 mm) (measurement x), and
the saw blade is set 5/64" to 5/32" (2 -
4 mm) above the riving knife (measurement
y)
English
6.1
6.2
6.3
11