Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
(The 3 steps below are not necessary for the searing side burner )
You will need to adjust the High Flame setting screw when converting the barbecue from Propane to Natural Gas.
Please follow the steps as shown below.
1.
Pull each Control Knob of main tube burners by hand.
2.
Use a precision screw driver to turn the High Flame Set Screw located inside the valve stem clockwise approximately 90 degree.
3.
Check that the burner operates at the new high flame setting - it may be necessary to adjust the screw setting slightly to get the
ideal burner flame height.
Warning!! Gas Valves are preset at the factory to operate on LP gas or NG gas. If you wish to convert, be sure to consult your gas
supplier or trained technician for the conversion.
A.
After the Natural Gas regulator has been installed to the grill, attach the PVC Gas hose to the regulator (See drawing below).
B.
Connect the other end of the PVC Gas Hose to the house gas line using the quick-connect fitting. To use the quick connect fitting,
lift the head of the connector back. Insert the end of the PVC hose and release the head of the connector. Double check that the
connection is secure.
There is a brass adapter for natural gas lines that are pre-regulated. If the gas line is not pre-regulated, remove the brass adapter and
connect the regulator directly to the PVC gas hose.
Once conversion is complete, please attach the NG CSA certification sticker to the grill.
If you should have any questions regarding natural gas conversion, please contact customer service at
1-800-4-MY-HOME
Natural Gas Conversion for Model# 122.33492410
For Main Tube Burner Conversion Only
27
Publicidad
Tabla de contenido
