Grill Lighting Instruction; Lighting Instructions - Kenmore 122.33492410 Manual De Uso Y Cuidado

Grill Lighting Instruction

Grill Lighting Instructions for Main Burners
1. Do not smoke while lighting grill or checking gas supply
connections.
2. Be sure that LP gas tank is sufficiently full.
WARNING
!
Failure to open grill lid during the lighting
procedure could result in a fire or explosion that
could cause serious bodily injury, death, or
property damage.
3. Be sure all gas connections are securely tightened.
4. Turn on gas supply.
5. Open the grill main lid.
6. Push and turn any main burner control knob to HI
position. Push Electronic Ignition button for 3 to 5
seconds to light burner.
7. If the burner does not light after 5 seconds, turn knob
to OFF. Turn gas OFF at LP tank and wait 5 minutes
for gas to clear. Then turn gas ON at tank and repeat
step 6.
8. If burner still does not light, see Match Lighting
section and If Grill Still Fails to Light section on
following page.
9. To light additional burners, turn burner knob(s) to
HI . Push and hold electronic ignition button to light
burner. Adjust knob(s) to desired setting.
USING THE SIDE BURNER:
Inspect the gas supply hose prior to turning the gas
"ON". If there is evidence of cuts, wear or abrasion, it
must be replaced prior to use. Do not use the side
burner if the odor of gas is present. WARNING: Always
keep your face and body as far away from the
burner as possible when lighting.
LIGHTING INSTRUCTIONS FOR SIDE BURNER
1. Make sure the lid is open.
2. Push and slowly turn the Rear Burner knob to IGNITE/ON
position. Keep knob pressed in until the burner is lit. Once
it is lit, continue to press and hold for another 15 seconds to
ensure the burner stays lit.
3. If burner does not light within 5 seconds, turn the knob to
OFF position and repeat the lighting procedure.
4. If burner fails to light after step 3, turn the knob to OFF
position, wait 5 minutes, then repeat the lighting procedure
or light by match.
7