Charge The Batteries; How To Use; Power Switch - Eureka 96 Guia Del Propietario

O
AA
10
ENGLISH
HOW TO ASSEMBLE

Charge the Batteries

Note: Charge the batteries for 14-16 hours before
initial use. A cleaner may lose charge in
shipment. The charger plug will become warm,
however this is not a cause for concern.
Note: If the batteries are completely void of charge, the
charging light may not shine until there is
sufficient charge in the batteries to provide power.
Step 1: Turn the nozzle
onto the bracket
from the cleaner and place battery in charging
stand.
K
Step 2: Charge light
AA
charger is connected with the power supply.
J
Charge light
AA
blinking when charge is complete.It is all right
to leave the cleaner on constant charge so it is
always ready to use. Unplug only if it will not be in
use for several weeks at a time.
Note: You can charge a battery in the unit and an extra
battery (optional) at the same time.

HOW TO USE

Power Switch

Note: On initial use, the clear plastic shipping switch
lock must be removed to activate the switch.
Pull on tab to remove.
Step 1: Push the power switch
up to turn off.
Step 2: Select type of cleaning. Carpet cleaning starts the
brush roll turning. Bare floor cleaning stops the
brush roll (Fig. 6).
Step 3: To use on bare floors or area rugs, make sure that
handle G is attached to the cleaner body (Fig. 7).
AA
Step 4: To use as a handvac remove handle
releasing the lock button
(continued)
down and lower the cleaner
O
AA
(Fig. 5) or remove the battery
I
AA
shows a steady glow after the
blinks while charging. It will stop
N down to turn on; push
AA
G
AA
M (Fig. 8).
AA
by